With this change all such frames will be added in front of the output queue, and
will be sent first. It prevents HOL blocking when response with higher priority
is blocked by response with lower priority in the middle of the queue because
the order of their SYN_REPLY frames cannot be changed.
Proposed by Yury Kirpichev.
If an error occurs in a SPDY connection, the c->error flag is set on every fake
request connection, and its read or write event handler is called, in order to
finalize it. But while waiting for request headers, it was a no-op since the
read event handler had been set to ngx_http_empty_handler().
If an error occurs in a SPDY connection, the c->error flag is set on every fake
request connection, and its read or write event handler is called, in order to
finalize it. But while waiting for a request body, it was a no-op since the
read event handler ngx_http_request_handler() calls r->read_event_handler that
had been set to ngx_http_block_reading().
Basically, this does the following two changes (and corresponding
modifications of related code):
1. Does not reset session buffer unless it's reached it's end, and always
wait for LF to terminate command (even if we detected invalid command).
2. Record command name to make it available for handlers (since now we
can't assume that command starts from s->buffer->start).
A server MUST send greeting before other replies, while before this
change in case of smtp_greeting_delay violation the 220 greeting was
sent after several 503 replies to commands received before greeting,
resulting in protocol synchronization loss. Moreover, further commands
were accepted after the greeting.
While closing a connection isn't strictly RFC compliant (RFC 5321
requires servers to wait for a QUIT before closing a connection), it's
probably good enough for practial uses.
With previous code only part of u->buffer might be emptied in case
of special responses, resulting in partial responses seen by SSI set
in case of simple protocols, or spurious errors like "upstream sent
invalid chunked response" in case of complex ones.
This patch fixes incorrect handling of auto redirect in configurations
like:
location /0 { }
location /a- { }
location /a/ { proxy_pass ... }
With previously used sorting, this resulted in the following locations
tree (as "-" is less than "/"):
"/a-"
"/0" "/a/"
and a request to "/a" didn't match "/a/" with auto_redirect, as it
didn't traverse relevant tree node during lookup (it tested "/a-",
then "/0", and then falled back to null location).
To preserve locale use for non-ASCII characters on case-insensetive
systems, libc's tolower() used.
Location tree was always constructed using case-sensitive comparison, even
on case-insensitive systems. This resulted in incorrect operation if
uppercase letters were used in location directives. Notably, the
following config:
location /a { ... }
location /B { ... }
failed to properly map requests to "/B" into "location /B".
Found by using auth_basic.t from mdounin nginx-tests under valgrind.
==10470== Invalid write of size 1
==10470== at 0x43603D: ngx_crypt_to64 (ngx_crypt.c:168)
==10470== by 0x43648E: ngx_crypt (ngx_crypt.c:153)
==10470== by 0x489D8B: ngx_http_auth_basic_crypt_handler (ngx_http_auth_basic_module.c:297)
==10470== by 0x48A24A: ngx_http_auth_basic_handler (ngx_http_auth_basic_module.c:240)
==10470== by 0x44EAB9: ngx_http_core_access_phase (ngx_http_core_module.c:1121)
==10470== by 0x44A822: ngx_http_core_run_phases (ngx_http_core_module.c:895)
==10470== by 0x44A932: ngx_http_handler (ngx_http_core_module.c:878)
==10470== by 0x455EEF: ngx_http_process_request (ngx_http_request.c:1852)
==10470== by 0x456527: ngx_http_process_request_headers (ngx_http_request.c:1283)
==10470== by 0x456A91: ngx_http_process_request_line (ngx_http_request.c:964)
==10470== by 0x457097: ngx_http_wait_request_handler (ngx_http_request.c:486)
==10470== by 0x4411EE: ngx_epoll_process_events (ngx_epoll_module.c:691)
==10470== Address 0x5866fab is 0 bytes after a block of size 27 alloc'd
==10470== at 0x4A074CD: malloc (vg_replace_malloc.c:236)
==10470== by 0x43B251: ngx_alloc (ngx_alloc.c:22)
==10470== by 0x421B0D: ngx_malloc (ngx_palloc.c:119)
==10470== by 0x421B65: ngx_pnalloc (ngx_palloc.c:147)
==10470== by 0x436368: ngx_crypt (ngx_crypt.c:140)
==10470== by 0x489D8B: ngx_http_auth_basic_crypt_handler (ngx_http_auth_basic_module.c:297)
==10470== by 0x48A24A: ngx_http_auth_basic_handler (ngx_http_auth_basic_module.c:240)
==10470== by 0x44EAB9: ngx_http_core_access_phase (ngx_http_core_module.c:1121)
==10470== by 0x44A822: ngx_http_core_run_phases (ngx_http_core_module.c:895)
==10470== by 0x44A932: ngx_http_handler (ngx_http_core_module.c:878)
==10470== by 0x455EEF: ngx_http_process_request (ngx_http_request.c:1852)
==10470== by 0x456527: ngx_http_process_request_headers (ngx_http_request.c:1283)
==10470==
The same path names with different "data" context should not be allowed.
In particular it rejects configurations like this:
proxy_cache_path /var/cache/ keys_zone=one:10m max_size=1g inactive=5m;
proxy_cache_path /var/cache/ keys_zone=two:20m max_size=4m inactive=30s;
The SSL_CTX_load_verify_locations() may leave errors in the error queue
while returning success (e.g. if there are duplicate certificates in the file
specified), resulting in "ignoring stale global SSL error" alerts later
at runtime.
Casts between pointers and integers produce warnings on size mismatch. To
silence them, cast to (u)intptr_t should be used. Prevoiusly, casts to
ngx_(u)int_t were used in some cases, and several ngx_int_t expressions had
no casts.
As of now it's mostly style as ngx_int_t is defined as intptr_t.
On win32, time_t is 64 bits wide by default, and passing an ngx_msec_int_t
argument for %T format specifier doesn't work. This doesn't manifest itself
on other platforms as time_t and ngx_msec_int_t are usually of the same size.
Several warnings silenced, notably (ngx_socket_t) -1 is now checked
on socket operations instead of -1, as ngx_socket_t is unsigned on win32
and gcc complains on comparison.
With this patch, it's now possible to compile nginx using mingw gcc,
with options we normally compile on win32.
