Assign a maximum ALQ value to each GLIFT producer when doing well testing
in beginTimeStep(). This allows the well to be considered open. Then,
later in the timestep, when assemble() is called, the full gas lift
optimization procedure can adjust the ALQ to its correct value.
It is also observed that in some cases when gas lift is switched off by
setting ALQ to zero, and later in the schedule is switched back on again,
it might not be possible to determine bhp from thp for low small ALQ values.
Instead of aborting the gas lift optimization, we should try increasing
ALQ until we get convergence or until the maximum ALQ for the well is
reached.
Adding explicit input specification of water-gas ratio (RVW) and RVW output plus simulator gas-water system with salt precipitation and water evaporation for
Sometimes the potentials are inaccurate as a safty measure we
also check that the rates are violated.
The rates are supposed to be less or equal to the potentials.
If no cell has a valid corner-point geometry, typically caused by
using GDFILE to read non-finite data such as all ZCORN = -1.0E+20,
then we must not attempt to generate a grid structure. If we do, we
will typically just fail somewhere deep down in the corner-point
processing code and generate a diagnostic message that's hard to
decipher.
With this commit we instead output a diagnostic message of the form
Failed to create valid EclipseState object.
Exception caught: No active cell in input grid has valid/finite cell geometry
Please check geometry keywords, especially if grid is imported through GDFILE
This may not be a lot better than the original diagnostic
Processing grid
flow: ${ROOT}/opm-grid/opm/grid/cpgpreprocess/preprocess.c:768: is_lefthanded: Assertion `! searching' failed.
Aborted (core dumped)
but does at least suggest that the grid data may be faulty.
In combination with the relevant changes in opm-common this
prevent flow in binary Linux packages from having a timestamp in the
executable that changes with every rebuild.
With the changes in opm-common one can now set the variable
OPM_BINARY_PACKAGE_VERSION to a meaningful version string (Debian
11.2: 2021.10-4). If that is done and flow is built from tarballs it
will now not have a time stamp and print the package version to the
PRT file. E.g.
Flow Version = 2021.10 (Debian 11.2: 2021.10-1)
If guiderate is violated change to group controll.
Note that a factor 1.01 is added to minimize oscilations.
Fix missing multiplication with group efficiency when accumulating guiderates
