This makes some tests succeed that use this deck only
for its properties and not its grid: if the grid in the
deck has fewer cells than the grid that is used for the
test we will fail in the SATNUM mapping.
While hopefully not a bug it raises an exception with gcc's
libc debugging mode. Therefore we resort to using C++11's
std::vector::data instead.
The exception was rosen when running SPE9 in parallel.
This commit introduces a new public method, activeRegions(), that
retrieves those region IDs that contain at least one active cell.
We furthermore extend the cells() method to support lookup of
arbitrary region IDs. Non-active region IDs produce empty cell
ranges.
Intended use case is
for (const auto& reg : rmap.activeRegions()) {
const auto& c = rmap.cells(reg);
// use c
}
calculations
The dz calculated in WellDetails::getCubeDim is not correct in cases
where the face centroid of the horizontal faces is located above or
below the face centroid or the vertical faces. The cell thickness in
EclipseGrid, calculated using the Z-coordinates, is therefore used
instead.
Unused methods and arguments have been removed,
and we avoid including the EclMaterialLawManager
in the header. Clients IncompPropertiesFromDeck
and BlackoilPropertiesFromDeck have been updated.
There is a sligth difference between the cell depth taken from the
centroid (opm) and a straightforward average of corner coordinates
(ecl). For the initialisation of Norne this causes some differences
when deciding cell center positions relative contact depths.
If on one process a well completion is next to border then
it might also be stored in the neighbor process. Still not
all the completions of the well are known to the neighbor.
This breaks the previous assumption that for each well all
completions must belong to the partition of the process.
Therefore with this commit we allow wells that only have a
part of their completions assigned to the partition of the process.
This wells are deactivated under the assumption that they must
exist completely on another process due to the partitioning.
- use time stepping algorithm pid instead of pid + iter
Adjusting the time-steps on the number of linear iterations does
currently not give any improvents on the time-stepping.
- Change the pid tolerance. The time-stepper will take longer time-steps
and thus reduce the simulation time significantly. The Norne and the SPE
results does not degrade
- Less aggressive reduction of time-steps after convergence problems
Previously well with just some shut completions errorneously triggered an
exception in parallel runs. This is fixed with this commit.
Due to the logic shut completions will always be marked as existing
on a process. (Initially all completions are marked as found. For
each open completion we check whether the cartesian index belongs to
the local grid. If that is not the case we mark it as not found).
Therefore we now check whether the found number of completions
is either the number of shut completions or the number of all completions.
In the former case the well is not stored on this process, and in the latter
case it is. In other cases we throw an exception.
